Category Archives: NETW 204 (recent)

NETW 204 Week 5 iLab recent

NETW 204 Week 5 iLab recent

Troubleshooting RIP and EIGRP vLab (30 points)
Write a paragraph (minimum five college-level sentences) below that summarizes what was accomplished in this lab, what you learned by performing it, how it relates to this week’s TCO’s and other course material; and just as important, how you feel it will benefit you in your academic and professional career. (10 points)
In this weeks lab I learned about problems that could occur in EIGRP routing if not configured completely.
I also learned what to look to determine where the connection problem may be and what steps need to be taken to correct the problem. We ended the lab with steps to ensure that the network is up and functioning.
Copy and Paste the following screenshots from your Troubleshooting RIP and EIGRP lab below.

For more Assignments visithttp://www.uopassignments.com

NETW 204 Week 4 iLab recent

NETW 204 Week 4 iLab recent

Subnetting IP Address, Configuring Static Routes and Static Host Table vLab (15 points)
Write a paragraph (minimum five college-level sentences) below that summarizes what was accomplished in this lab, what you learned by performing it, how it relates to this week’s TCO’s and other course material; and just as important, how you feel it will benefit you in your academic and professional career. (7 points)
This lab’s scenario involves creating a simple network for a small business using static routes. Our first task is to subnet the given IP address and into 5 usable subnets, plus one remainder, and map out the addresses for the router interfaces. Then we systematically log in and enable privileged exec mode on the host router, the serially connected router and then the remote router. After that we repeat the process but this time we configure the interfaces and ip addresses from each router. When the interfaces are configured we can use the show ip interfaces command to verify that each interface is showing directly connected networks. From there we configure static routes to reach networks that are not directly connected. Finally we verify connectivity using the “show ip route” command.
Copy and Paste the following screenshots from your Subnetting IP Address, Configuring Static Routes and Static Host Table lab below.

For more Assignments visithttp://www.uopassignments.com

NETW 204 Week 1 Quiz recent

NETW 204 Week 1 Quiz recent

1. (TCO 1) Where is the running configuration located?
2. (TCO 1) Which routing principle is correct?
3. (TCO 3) A routing protocol where the routing updates do not carry subnet information and, in turn, do not support variable-length subnet masks. This limitation makes it impossible to have different-sized subnets inside the same network class.
4. (TCO 2) Which of the following is a function of the IOS command show cdp neighbors?
5. (TCO 3) Which of the following technologies can be used in distance-vector routing protocols to prevent routing loops?
6. (TCO 3) Which of the following prompts indicates that you are in privileged mode?
7. (TCO 3) How many equal-cost paths can a dynamic routing protocol use for load balancing by default?
8. (TCO 3) Which statement is not true regarding some distance-vector routing protocols?
9. (TCO 3) When do directly connected networks appear in the routing table?
10. (TCO 3) What allows RIP to avoid routing loops by advertising a metric of infinity?

For more Assignments visithttp://www.uopassignments.com